





55mm Alfa-lava pump mechanical seal replacement
- Used in Alfa Laval SRU Rotary Lobe Pumps,Wave spring, for oil, water, sewage, and weak corrosive liquids.
Description:
- Wave Spring Pusher Mechanical Seals for for Alfa Laval SRU Rotary Lobe Pumps
Operating Limits:
- Temperature:-10-120℃
- Speed: 10m/s
- Pressure: 12bar
- Standard size: 55mm
Materials:
- Seal ring: Car,Sic,Ssic,TC
- Secondary seal: NBR,EPDM,Viton etc.
- Spring and metal parts:304,316,HAST.C
Some others you may like
A 55mm Starting Point, with the Fit Details in View
This replacement is listed for Alfa Laval SRU rotary lobe pumps with a 55mm seal size. That measurement starts the selection; it does not complete it. Compare the removed seal's stationary seat, locating features and installed length with the proposed replacement before ordering. Include a pump nameplate photo and clear views of both seal faces so that a similar-looking part is not mistaken for a confirmed fit.
Material Choices Explained Around Your Pumped Liquid
The listed face options include carbon, silicon carbide and tungsten carbide, with NBR, EPDM or FKM secondary seals. A useful enquiry names the liquid, its temperature and any cleaning chemicals, rather than requesting only a “55mm seal.” Specify the required face pairing and elastomer together; the same external dimensions can contain materials intended for different duties.
Wave-Spring Details Included in the Replacement Check
This page describes a wave-spring pusher arrangement. When comparing an old assembly, record how the spring, rotating face and stationary seat are positioned. A loose seal's overall height should not be treated as its working length. Keep the original assembly orientation in your photos and check the pump's installation instructions before fitting the replacement.
A Clearer Record for the Next Maintenance Order
Once the replacement specification is confirmed, retain the pump identification, seal dimensions, face materials and elastomer grade as one maintenance record. Add photographs of the accepted assembly and note any differences from the removed part. The next enquiry can then refer to a documented configuration instead of relying on the nominal diameter or a previous product photograph alone.
Production Process
Production Line
Equipment






